WhatsApp)
Ceramic waste powder is of cement or as a partial replacement of fine aggregate sand as a supplementary addition to achieve different properties of concrete. International Journal of Engineering Trends and Technology (IJETT Concrete on 30% replacement of Cement .
to partial replacement of the fine aggregate with marble powder. M25 of concrete mix has been taken and casted into cubes and astrength tests have been conducted. In this paper I conduct an experiment on partial replacement of sand with marble dust powder at different % of mdp which are 20,25,30,35,40%.
[12], studied the replacement of cement or sand by marble powder for improvement in concrete properties. It shows that sand replacement gives better results as compare to cement replacement. Also, AlirezaNaji et al. [9], studied that average particle size of rice husk provides positive effect on compressive
curing. The results of the laboratory work showed that replacement of cement with Marble dust powder increases up to 10% for both compressive strength and split tensile strength of concrete. Keywords: Marble Powder, Cement, Compressive Strength, Split Tensile Strength
Table 3: Sand Marble powder: Marble powder was collected from the dressing and processing unit in Jalgaon. It was initially in wet form ( slurry); after that it is dried by exposing in the sun and finally sieved by IS90 micron sieve before mixing in concrete.
The replacement of cement and sand by marble powder (MP) at substitution rate of 10% decreases the compressive strength of mortars, and mortars with MP substituted by sand performed better than
main objective of this study is to develop useful concrete mixes using waste marble powder as partial replacement of cement and sand. Keywords: Waste marble powder, concrete, compressive strength, flexure strength, splittensile strength, workability, durability. I. INTRODUCTION. Marble is obtained from the transformation of pure limestone.
Based on the experiment result it showed that replacement of cement and sand by marble powder up to 10% increases the compressive strength but above 10% content of marble powder decreases the compressive strength. Split tensile strength increases with increase in marble powder dust.
Table 3: Sand Marble powder: Marble powder was collected from the dressing and processing unit in Jalgaon. It was initially in wet form ( slurry); after that it is dried by exposing in the sun and finally sieved by IS90 micron sieve before mixing in concrete.
V. CONCLUSION From the test results it is clearly evident that granite powder as a partial replacement of sand proves to be beneficial when Durability properties of Concrete is considered. Durability of Concrete using Granite Fines is almost same as that of reference mix (GF0), However at 30% replacement compared to other proportions yielded better durability.
International Journal of Latest Technology in Engineering, Management amp; Applied Science (IJLTEMAS) Volume VI, Issue VI, June 2017 | ISSN Page 147 Replacement of Cement and Sand in Concrete with Waste Marble Product Ruchi Chandrakar1, Avinash Singh2 10% replacement of sand with marble dust powder. 3.
Inuence of limestone waste as partial replacement material for sand and marble powder in concrete properties Omar M. Omar a, Ghada D. Abd Elhameed b,*, Mohamed A. Sherif a, Hassan A. Mohamadien c a Department of Civil Construction and Architecture, Faculty of Industrial Education, Suez, Egypt b Building Materials Research and Quality Control Institute, Housing and Building National Research
Concrete of M25 grade was designed for a w/c ratio of for the replacement of 10% coarse aggregate with recycled coarse aggregate and replacement of 50, 60 and 70% of fine aggregate (sand
Concrete Using Marble Sludge Powder and Crushed Rock Dust. KSCE Journal of Civil Engineering (2012) 16(6):980988 DOI /sy [5] Omar, (2012). Influence of limestone waste as partial replacement material for sand and marble powder in concrete properties.
#0183;#32;Influence of limestone waste as partial replacement material for sand and marble powder in concrete properties. Housing and Building National Research Center (HBRC) Journal, 8, 193203. Baboo R., Khan, Abhishek Kr., Tabin, amp; Duggal (2011). Influence of
Jarofix in Concrete, International Journal of Civil Engineering and Technology, 9(5), replacement for sand in concrete and the study concluded that the replacement of 5% welding [19] studied on partial replacement of fine aggregate by granite powder in concrete and found that 40% of the fine aggregate can be replaced with granite powder.
after the study shows that marble powder can be used as a replacement for cement. It is the concluded that the best proportion of marble dust powder is 10% with 28 days of curing for compressive strength test. Does not are affect the setting time of concrete after use of marble dust in concrete
[1] Nitisha Sharma studied the properties of Waste Marble Powder as a Partial Replacement in Cement Sand Mix This was done by replacing cement by a percentage of marble powder. Four basic concrete mixes were considered. When cement is replaced with marble powder up to 10% weight, high strength concrete was achieved.
Properties of concrete incorporating sand and cement with waste marble powder Methods . Workability . In accordance with IS 7320 (1974), slump test was performed for workability, Different
WhatsApp)